ansys workbench static structural analysis examples

Ansys workbench static structural analysis examples free#

If the mesh for the contact interface is course then Ansys might not recognise the components and hence will fly off into space.Īlso if the contact is initially closed but there is a large gap between the mating components then the components will pass through each other. This involved placing the pile on the seabed, suction the water out of the structure and use that differential under pressure to push the device into the soil. These devices are essentially a cylinder with one end open.

Ansys workbench static structural analysis examples free#

Please feel free to ask anything I may have missed out on that would aid in my situation and I will respond ASAP. This Structural Analysis Example Piles on the Material Savings Suction piles are a fascinating offshore mooring technology.

I apologize if I missed out on a lot of crucial information. I hope this is a simple fix and i'm just missing something very simple. My problem is that when I solve for it, the blocks vanish as if its not there. I have forces applied onto the blocks as well as frictionless supports for where I cut it in half (due to symmetry) A difference of 1.32 was detected between the. I'm not sure if this is a good method but to save time I am doing this method for now. These models were analyzed under the same conditions in the static analysis module via ANSYS workbench. Under connections->contacts, I have frictionless contacts between the face of the pipe (target) and the profile of the gripping blocks (contact).Īs for meshing, I'm currently just doing a very coarse test to see if the analysis works. The pipe is clamped by equal and opposite forces being applied on each block.

Inside of this directory is where all the mysterious and automatic stuff.

The typical Workbench project will have, at the top level directory, a .wbpj file and a files directory, as shown in the picture above.

The blocks have a profile on them that grip the pipe. The ANSYS Workbench file system for an ANSYS Mechanical project, including the temporary solution directory.

Basically what i'm trying to model is a piece of pipe being clamped by two blocks. Answer (1 of 2): First you have to prepare geometry (either make it in ANSYS or import from CAD software), then choose material from library or provide basic properties of your own material. My project currently involves analyzing the stresses and deformation occuring on the gripping blocks as well as the piece of pipe. Any feedback and help is greatly appreciated! Please refer to the photos attached for referral. First off, I'd like to mention that I am completely unfamiliar with this ANSYS and have been fighting with this program for last 2 and half weeks.